diamond cutting depth is related to wear

saw cutting force conditions and the nature of the important parameters of stone. Generally speaking, when the line speed diamond saw blade is high, should be selected for cutting of small depth, from the stone polishing pads  current technology, the cutting depth of the diamond can choose between 1mm ~ 10mm. Usually with a large diameter saw blade cutting granite blocks, the cutting depth can be controlled within 1mm  2mm between the feed rate should be reduced at the same time. When the line speed diamond saw blade is large, a large cutting depth should be selected. But in performance and tool strength saw the extent permitted, should try to take a greater depth of cut for cutting to improve cutting efficiency. When the machined surface flap discs  when requested, should be used small depth of cut.
 Feed speed: Cutting feedrate incurs stone feed rate. Its size sawing rate impact, the force and the cutting blade heat dissipation area. Its value should be based on the nature of the selected cutting stone. Generally speaking, sawing softer stone, such as marble, may be Diamond tool  appropriate to increase the feed speed, if the feed rate is too low, more conducive to high cutting rates. Sawing fine structure, relatively homogeneous granite, may be appropriate to increase the feed speed, feed rate is too low if the diamond blade easily be polished. But sawing UNEVEN coarse granite structure, should reduce feed speed, otherwise it will cause the blade vibration and reduce fragmentation leading diamond cutting rates. Granite cutting feed rate is generally 9m ~ 12m/min within the selected range.