the drill should be packed in special packing boxes

1, the to avoid vibrations collide.
2, when used, from packing boxes should immediately remove the drill bit attached to the spindle collet header or automatic replacement drill tool library. Spent immediately put back packing boxes.
3, use the drill diameter measurement tool microscope and other non-contact measurement equipment, to avoid the cutting edge in contact with the mechanical gauge was bruised.
4, some CNC drilling machine CNC drilling using some positioning ring retaining ring is not used, such as the use of its positioning ring installation depth positioning must be accurate, as it does not use retaining ring fitted to the drill spindle elongation to adjust consistent, multi-spindle drilling machine to pay attention to this point, to make each spindle drilling depth to be consistent. If not possible to make drill drill drill through the surface or not caused by circuit board scrap.
5, using 40 times the usual three-dimensional microscopy drill blade wear.
6, the spindle and to always check the concentricity of the collet and the collet chuck clamping force, will result in poor concentricity of small diameter drill bit off and pore size, etc., the tct blades  clamping force will cause the actual speed is not good Set speed does not match between the chuck and the drill bit slipping.
7, fixed shank drill head clamping collet drill shank length of 4 to 5 times the diameter to clamp securely.
8, should always check the spindle presser foot. Presser foot contact surface perpendicular to the spindle is horizontal and not shaking, to prevent drilling off the drill and produce partial holes.
9, drilling better than vacuuming, vacuum air temperature can be reduced drill, colleagues away dust reduce friction generates heat.
10, the substrate stack comprises upper and lower plate to drill a hole workbench trough positioning system to locate a prison, lie flat. Use adhesive tape to prevent the drill bit to be on the tape so that a drill swarf adhesion, causing difficulties and chip off the diamond.
11, ordering manufacturers drill, the  Plate Compactor factory inspection when sampling the compliance of its 4%. And 100% of 10 to 15 times with a microscopic examination of the gaps, scratches and cracks.
12, drill timely re-grinding, increase the use and re-drill grinding times, extending bit life, reduce production costs and expenses. Microscope usually measured length of the two main cutting edges, the wear depth should be less than 0.2mm. Regrinding when rubbed 0.25mm. Plain shank drill can be reground three times, shovel-shaped head (undercut) of the drill can be reground two times. Excessive turning grinding quality and accuracy of its drilling will decline, will cause the finished circuit board scrap. Excessive turning mill backfired.
13, when the wear due to abrasion and 14 inch saw blade  diameter reduction of 2% compared to the original, then the bit scrapped.
14 bit parameter settings in general, manufacturers have to provide a drill bit plant production speed and lower speed parameter table, the parameter is a reference only, the actual craft workers through actual use but also draw a line with The actual speed and the speed of the drill parameters are usually the reference parameter actual parameters are different but the difference is not too much.